Deployment Guide
Deploying the iLOQ 5 Series locking system
- Deployment for Utilities Industry
  - Adding the First Programming key and Attaching It to a User
    This section describes how to add the first Programming key to iLOQ Locking System, and how to attach the Programming key to a user.
  - Adding Administrative User Credentials
    This section describes how to add administrative user credentials to iLOQ Locking System.
  - Adding Additional Programming keys and Attaching them to Users
    This section describes how to add additional Programming keys to iLOQ Locking System, and how to attach them to users.
  - Enforcing Logins with a Token
    This section describes how to enforce logins with a token.
  - Adding Floor Plans
    This section describes how to add floor plans to iLOQ Locking System.
  - Adding Access Rights
    This section describes how to add access rights to iLOQ Locking System.
  - Adding a New Lock onto the Floor Plan
    This section describes how to add a single lock directly onto a floor plan.
  - Adding New Persons
    This section describes how to add new persons to iLOQ Locking System.
  - Adding S5 Keys
    This section describes how to add S5 keys to iLOQ Locking System.

Adding a New Lock onto the Floor Plan

This section describes how to add a single lock directly onto a floor plan.

Tip:

To add several locks at a time, see Adding S5 Locks.

Note:

You do not necessarily need the actual physical locks to add locks in iLOQ Locking System. You can define the locks and attach them to the physical locks at a later phase.

Note:

Required fields are marked with an asterisk (*).

Proceed as follows.

Select Basic data > Browse floor plans.
Select the desired floor plan.
Hover your mouse over the desired door and right-click to select Lock > Add lock (Ctrl+N).
The Add lock wizard is opened.
Select Add lock.
Depending on the lock type that you are adding, select one of the instructions below to proceed: