Adding Floor Plans

This section describes how to add floor plans to iLOQ Locking System.

Floor plans are PDF or image files that depict the room and door layout for the premises where the iLOQ Locking System will be deployed at. The floor plan can also be a map, showing the location of locks on a geographical area.

The supported files types are:

  • PDF
  • Most common image file types
Note:

DWG files are not supported.

Note:

Required fields are marked with an asterisk (*).

Proceed as follows.

  1. Select Basic data > Floor plans.
  2. Select Add floor plan.
    The Add floor plan wizard is opened.
  3. Select the file that contains the floor plan.
  4. The next options depend on the image file type.

    If your floor plan is a PDF file:

    • Select the Page number where the desired floor plan is on.

    If your floor plan is an image file in, for example, the PNG format:

    • Check that the figure looks as planned in the preview.
  5. Optional: If necessary, flip or rotate the image, and change the image size with the tools provided at the footer of the Floor plan file screen.
  6. Click Next.
  7. Name the floor plan.
  8. Enter a description of the floor plan.
  9. Click Next.
  10. Select the estate for the floor plan.
  11. Click Next.
  12. Select the zone for the floor plan.
  13. Click Ready.
  14. The figure is uploaded on the server.
  15. Check that the figure is sharp enough.
    If the figure is not sharp enough, replace the figure.