Adding Floor Plans

This section describes how to add floor plans to iLOQ Locking System.

Floor plans are PDF or image files that depict the room and door layout for the premises where the iLOQ Locking System will be deployed at. The floor plan can also be a map, showing the location of locks on a geographical area.

The supported files types are:

  • PDF
  • Most common image file types
Note:

DWG files are not supported.

Note:

Mandatory fields are marked with an asterisk (*).

Proceed as follows.

  1. Select Basic data > Floor plans.
  2. Select Add floor plan.
    The Importing of Floorplan wizard is opened.
  3. Select Import new floor plan.
  4. Click the ... button and select the file that contains the floor plan.
  5. Select Open.
  6. Select Next.
  7. The next options depend on the image file type.

    If your floor plan is a PDF file:

    • Select the Page number where the desired floor plan is on.
    • Select the desired Resolution for the imported figure.

    If your floor plan is an image file in, for example, the PNG format:

    • Check that the figure looks as planned in the preview.
  8. Select Next.
  9. Check the image file size in the Size field.
    If the file size exceeds 1 MB:
    1. Select Back.
    2. Select a figure with a smaller file size or, in the case of a PDF file, reduce the Resolution for the imported figure.
    3. Select Next.
  10. Name the floor plan.
  11. Select Next.
  12. A summary screen is shown.
  13. Select Ready.
  14. Select Close.
  15. The figure is uploaded on the server.
  16. Check that the figure is sharp enough.
    If the figure is not sharp enough, replace the figure.