This section describes how to program new locks in
iLOQ Manager.
When a new lock cylinder is delivered from the factory, it is in the
factory state, and can be taken into use in any iLOQ S50 Locking System.
This is the usual way of adding new locks. However, you can also add lock through the
floor plan. See Adding a New Lock onto the Floor Plan.
Proceed as follows.
-
Select .
-
Select the locks to be programmed.
-
Right-click to select Program lock.
The Programming of locks wizard is opened.
-
Select Program locks.
-
A list of locks to be programmed is shown.
-
Select Next.
-
Select Program locks.
-
Select Next.
-
A summary screen is shown.
-
Select Ready.
-
A status screen is shown, displaying the lock that is next in the programming
queue.
-
Follow the instructions on the programming status screen.
-
A summary screen is shown.
-
Select Close.
-
The programmed locks appear in the lock grid view in the Programmed
state.
