This section describes how to program locks on iLOQ Manager.
Proceed as follows.
Select Basic data > Browse locks.
Select the locks to be programmed.
The selected lock must be in the Ordered or
Transferred to programming state. If the lock is
in the In planning state, order the lock first. See
Ordering Locks.
Right-click to select Program lock.
The Programming of locks wizard is opened.
Select Program locks.
A list of locks to be programmed is shown.
Select Next.
Select Program locks.
Select Next.
A summary screen is shown.
Select Ready.
A status screen is shown, displaying the lock that is next in the programming
queue.
Figure: Programming Status Screen
Insert the programming cable to the requested lock.
Follow the instructions on the programming status screen.
A summary screen is shown.
Select Close.
The programmed locks appear in the lock grid view in the Programmed
state.
